FLAT-11
Characteristics
Length: 453
Width: 269
Weight: 3,15
Units/sq.m.: 11 tejas
Useful length: 350 - 385 mm
Units per ml eave line: 4 tejas
Minimum pitch recommended: 30% – 17º (*)
Useful width: 238 mm
Pallet info: 240 units / 750 Kgs. – 320 units / 1.020 Kgs.
Minimum order: 4 tejas
FLAT roof tiles
The Flat-11 roof tile is a flat ceramic tile, available only in special finishes. The optimum installation on pitched roofs is on a battens system or equivalent. The Flat-11 tile is a flat tile suitable for staggered and in-line installation. The minimum recommended slope is 30% or 17º. With 11 tiles per sq.m., they are installed by means of the lateral and longitudinal deep interlocks. They are fixed with screws through the pre-marked holes. It has variable useful batten (from 35 to 38.5 cm).
Approximate values: If the roof tiles are installed on battens, the useful length must be calculated on site. A tolerance of ± 2% is allowed on the dimensions of the roof tiles according to UNE-EN 1024.
(*) In zone 1 (protected area), arranged in staggered formation with waterproof laminate and batten distance of 350 mm on a skirt of up to 6.5 m. Check pitch pannel according to the roof length and the geographical area according to UNE-EN 136020. In case of continuous joint fitting, waterproofing of the support is necessary in all cases.
Quality approvals (downloads)
CE
CE Marking on a product is a manufacturer’s declaration that the product complies with the essential requirements of the relevant European health, safety and environmental protection legislation, in practice by many of the so-called Product Directives.
Applicable to finishings:
MIAMI-DADE
The certification MIAMI-DADE is issued under government rules implementing products for construction in Miami Dade County and other dependent areas.
MIAMI-DADE conformity shows that certified products have been tested and meet building regulations (ASTM C 1167), being designed according to technical Florida Building Code High Speed hurricanes.
Applicable to finishings: